What to pay attention to when using a vacuum cleaner？

1. Before use, the vacuum cleaner hose should be correctly connected with the vacuum cleaner nozzle holder, and the hose should be tightened with each section of the super-long nozzle and the nozzle at the end of the nozzle, such as furniture brushes, crevice nozzles, floor brushes and other prisons. Since there are fewer air inlets for the gap suction nozzles, the noise is louder during use, and the duration should not exceed 1 hour to prevent the motor from overheating and burning.

2. When using the vacuum cleaner, the most annoying thing is the hot smell of the exhaust port. Before using the vacuum cleaner, you can use cotton dipped in lemon juice and put it into the vacuum cleaner's suction tube, so that when you go to vacuum with this "added" vacuum cleaner, not only is there no smell in the room, but it will also float. Light lemon scent.

3. Dump the dust and sundries in the dust bag, wash with detergent, then wash with clean water and dry in the sun. If you leave it in the vacuum cleaner without drying, the dust bag will be very dirty when the vacuum cleaner vacuums again. For the part of the vacuum cleaner that is attached to the ground, in addition to brushing your teeth with a brush, you can also use a toothpick or bamboo skewer to take out the tangled garbage. Due to the strong adhesion, silk and hair can only be removed by hand.

4. The vacuum cleaner shall not be used to absorb sticky objects and metal conductor powder. Vacuums cannot be used to pick up large paper balls, plastic bags, tape and hard sharp objects. The nozzle of the vacuum cleaner and the nozzle of the floor should be stored separately for disinfection. Always remove the filter cloth when absorbing water.

5. When in use, the suction control device can be properly adjusted according to the cleaning occasion. The elbow has a round hole with an adjustment ring on it. Suction is greatest when the adjusting ring covers the hole in the elbow, and least when the adjusting ring is fully exposed through the hole. Some vacuum cleaners use motor speed regulation to adjust suction power.